Kilogram/cubic meter = gram/liter, kilogram/liter = gram/cubic centimeter = ton(metric)/cubic meter, once/gallon(US liquid) pound/cubic inch, pound/cubic foot, pound/gallon(UK), pound/gallon(US liquid), slug/cubic foot, ton(short)/cubic yard, ton(long)/cubic yard The density of liquid benzene is nearly the same for all pressures up to 100 bara, and the density of the liquid at equilibrium pressure can be used for most practical purposes.ĭensity of benzene vapor (singel phase) at varying temperature and given pressures, SI and Imperial units:ĭensity and specific weight of benzene at given temperatures and pressures:įor full table with Density and Specific Weight - rotate the screen! Benzene - Density and Specific Weight vs. Density of crude oil, Density of fuel oils, Density of lubricating oil and Density of jet fuel as function of temperature.ĭensity and specific weight of liquid benzene at varying temperature and pressure, SI and Imperial units:ĭensity of benzene along the boiling and condensation curve, SI and Imperial units: Other properties of Benze ne at varying temperature and pressure: : Dynamic and kinematic viscosity, and Thermophysical properties at standard conditions ,Īs well as density and specific weight o f acetone, air, ammonia, argon, butane, carbon dioxide, carbon monoxide, ethane, ethanol, ethylene, helium, hydrogen, methane, methanol, nitrogen, oxygen, pentane, propane, toluene and water. Ĭhoose the actual unit of temperature: ☌ ☏ K °R Specific weight is given as N/m 3 and lb f / ft 3. The output density is given as kg/m 3, lb/ft 3, lb/gal(US liq) and sl/ft 3. Note! Benzene boiling point at atmospheric pressure is 80 ☌ (176☏), and hence, benzene must be pressurized to remain liquid at higher temperatures than that. The calculator below can be used to estimate the density and specific weight of liquid benzene at given temperature (maximum 250☌ or 620 ☏) and maximum 28 bara (400 psia). Tabulated values of benzene density and specific weight at given temperature and pressure (SI and Imperial units) as well as density units conversion are given below the figures.
![density of water at 20 degrees celsius density of water at 20 degrees celsius](https://www.engineeringtoolbox.com/docs/documents/595/Water_density_temp_pressure_F.jpg)
Where g = acceleration due to gravity, units typically and value on Earth usually given as 9.80665 or 32.17405 Specific weight, γ, has units typically or is defined by the ratio of the weight to the volume of a substance: Density, ρ, has units typically or, and is defined by the ratio of the mass to the volume of a substance: